With the introduction of the B100, there is USB support
using UHD devices. The characteristics of the trasmit
side burst submissions are more reflective of the bus
type than the device or driver.
Use a fixed latency interval for network devices and the
adaptive underrun approach for USB devices - regardless
of driver or device type.
The GPMC based transport on the E100 appears unaffected
by either latency scheme, which defaults to network.
Signed-off-by: Thomas Tsou <ttsou@vt.edu>
git-svn-id: http://wush.net/svn/range/software/public/openbts/trunk@2677 19bc5d8c-e614-43d4-8b26-e1612bc8e597
Move push and pull of buffers into a dedicated file. This will
allow us to swap out resampling, non-resampling, and possibly
floating point device interfaces while presenting a single
floating point abstration in the interface itself.
Signed-off-by: Thomas Tsou <ttsou@vt.edu>
git-svn-id: http://wush.net/svn/range/software/public/openbts/trunk@2670 19bc5d8c-e614-43d4-8b26-e1612bc8e597
Remove radio clock and vector interfaces into their own
files. This clears up and simplifies the radio interface
and, additionaly, prepares for a further split of the I/O
portion for optional resampler use.
Signed-off-by: Thomas Tsou <ttsou@vt.edu>
git-svn-id: http://wush.net/svn/range/software/public/openbts/trunk@2669 19bc5d8c-e614-43d4-8b26-e1612bc8e597
Commit e161523c (transceiver: simplify transmit power control)
changed transmit gain control to RF setting only. This was
appropriate for a WBX board with 25 dB of gain control, but
inappropriate for an RFX with fixed transmit gain.
RFX boards will regain the ability to set transmit
attenuation. Since gain is set on the RF side first,
reintroducing digital gain settings should have limited
overall effect on non-RFX daughterboards.
Signed-off-by: Thomas Tsou <ttsou@vt.edu>
git-svn-id: http://wush.net/svn/range/software/public/openbts/trunk@2660 19bc5d8c-e614-43d4-8b26-e1612bc8e597
UHD will internally accept floats with a range of +/-1.0,
which corresponds to a 16-bit signed integer range of
apporximately +/- 32000. Set the default amplitude to .3,
which is a safe value agaist saturation elsewhere in the
transmit chain.
The non-UHD maximum amplitude is unchanged at 13500.
Remove digital gain control because it's unnecessary and
causes extra load on enbedded systems.
Signed-off-by: Thomas Tsou <ttsou@vt.edu>
git-svn-id: http://wush.net/svn/range/software/public/openbts/trunk@2654 19bc5d8c-e614-43d4-8b26-e1612bc8e597
Push the ability to set thread priority out to the 52M
Transceiver interface, because that's where the thread
control exists.
Signed-off-by: Thomas Tsou <ttsou@vt.edu>
git-svn-id: http://wush.net/svn/range/software/public/openbts/trunk@2644 19bc5d8c-e614-43d4-8b26-e1612bc8e597
